Case International B Series B275 Electrical PARTS
Ignition Switches
-
£15.00 Inc VAT £12.50 Exc VATIn stockPart No.50777 -
Premium Ignition Switch, Heat and start suitable for Case International - 3048227R92 Premium Quality ignition switch,Heat and start, 4 terminals.£21.60 Inc VAT £18.00 Exc VAT2-3 working daysPart No.74911
Wiring Looms
-
Wiring Harness B250 B275 B414 suitable for Case International - Suitable for models with lever type starter motor.£41.99 Inc VAT £34.99 Exc VAT2-3 working daysPart No.5018
Starter Motors
-
Starter Motor suitable for Case International - Lucas M45 Type.
12V.
2.2 kW.
LH Fit.
Fitting: 3 Hole.
Flange RH Opening.
Teeth: 10.
£118.80 Inc VAT £99.00 Exc VATIn stockPart No.8021 -
Starter Motor suitable for Case International - 704447R94 Early IHC Lever Type (1958 - 1964)Supplied With Rubber Boot Which Sits Over The Top Of The Lever.£178.80 Inc VAT £149.00 Exc VATIn stockPart No.8153
Starter Accessories
-
Contact Switch Starter Motor suitable for Case International - Contact Switch Starter Motor£18.00 Inc VAT £15.00 Exc VATIn stockPart No.5063
-
Rubber Boot - Starter suitable for Case International - Made from Synthetic durable rubber£11.40 Inc VAT £9.50 Exc VATIn stockPart No.5191
-
Currently unavailablePart No.9042
Dynamos
-
Tractor Dynamo suitable for Case International - 3049871R91 K908882
These 12V dynamo are a direct replacement for the Original Lucas C40 dynamo, with a single spade on the rear and a lug on the side.
These dynamos have been redeveloped to be fully weather proof; the positi... Show More
£66.00 Inc VAT £55.00 Exc VATIn stockPart No.5297
Dynamo Pulley
-
Dynamo Belt - A29 suitable for Case International - 70444R1 709449R1Dynamo Belt - A29 typeSuitable for Case IH - Dynamo BeltType: SmoothDimensionsOutside Length: 787mmInside Length: 735mmTop Wid... Show More£6.00 Inc VAT £5.00 Exc VAT2-3 working daysPart No.8019A
Heater Switches
-
Resistor suitable for Case International - 3042230R91 703557R92 706685R92 ResistorDimensions / Spec- 2 Ohm- Fitting Diameter: 25.40mm- Overall Length: 56.3mm£21.00 Inc VAT £17.50 Exc VATIn stockPart No.8072
Heater Plug
-
Glow Plug - 710348R1 suitable for Case International - 710348R1Glow PlugDimensionsThread: No.18 BS Spark Plug. 18mm x 1.5 PitchNote that these must be wired in series£15.00 Inc VAT £12.50 Exc VAT2-3 working daysPart No.5721
Solenoid
-
Starter Solenoid suitable for Case International - Fixing Studs 42mm Spacing£24.00 Inc VAT £20.00 Exc VAT2-3 working daysPart No.9061
-
Solenoid suitable for Case International - 12V SolenoidMounting Centers: 40mm£11.99 Inc VAT £9.99 Exc VATIn stockPart No.5171
-
Starter Solenoid suitable for Case International - Genuine Lucas.£21.59 Inc VAT £17.99 Exc VAT2-3 working daysPart No.9029
Coil
-
Currently unavailablePart No.9046
Condensor
-
£7.50 Inc VAT £6.25 Exc VATIn stockPart No.5084
Contact Sets
-
£7.32 Inc VAT £6.10 Exc VATIn stockPart No.5086
Rotor Arms
-
£5.40 Inc VAT £4.50 Exc VATIn stockPart No.5090
Horn
-
£15.00 Inc VAT £12.50 Exc VAT2-3 working daysPart No.5121
Horn Button
-
Horn Button suitable for Case International - Horn Button2 TerminalFitting Diameter: 19mm£9.00 Inc VAT £7.50 Exc VAT2-3 working daysPart No.5120
-
Horn Button suitable for Case International - Genuine Lucas.£24.98 Inc VAT £20.82 Exc VAT2-3 working daysPart No.9049
Gauges
-
£18.00 Inc VAT £15.00 Exc VAT2-3 working daysPart No.5056
-
Water Temp Gauge suitable for Case International - Water temp gaugeDimensions- Body OD: 52mm- Bezel OD: 57mm- Wire Length: 190cm- Sender Thread OD: 15.3mm&... Show More£18.00 Inc VAT £15.00 Exc VAT2-3 working daysPart No.5055
Oil Pressure Gauge B275 B414 B434 suitable for Case International - Case/IH. B275 - From Serial Number 8523 OnwardsDimensions- Body OD: 51.80mm- Bezel OD: 57mm- Thread OD: 9.5 - 10.2mm<... Show More£18.00 Inc VAT £15.00 Exc VAT2-3 working daysPart No.5054
Tachometers
-
Tachometer B275 B414 suitable for Case International - Tachometer Early Type Use Tachometer Cable 9054£33.60 Inc VAT £28.00 Exc VATOut of stockPart No.5126
Tachometer Cables
-
Tachometer Cable suitable for Case International - 3042473R91 Tachometer Cable Suits 5126 - Early Type Tachometer Length: 930mm Thread: M12 - M12£17.99 Inc VAT £14.99 Exc VAT2-3 working daysPart No.9054
Number Plate Lamps
-
Number Plate Lamp suitable for Case International - 3053400R92 Number Plate Lamp£8.96 Inc VAT £7.47 Exc VAT2-3 working daysPart No.8220
Light Switches
-
Light Switch & Knob as Original - 882283M1 suitable for Case International - 3107344R91 Light Switch & Knob as Original7 Terminal (3 Double, 1 Single)13.5mm Fitting Diameter.£17.99 Inc VAT £14.99 Exc VATIn stockPart No.5377
Headlight Spares
-
Bulb 12V 5W BA15D SBC G18.5- Single suitable for Case International - Side/Indicator bulb ECC Approved.£0.42 Inc VAT £0.35 Exc VATIn stockPart No.9365
-
Bulb 12V 5W BA15D SBC G18.5- Box 10 suitable for Case International - Side/Indicator bulb ECC Approved.£3.60 Inc VAT £3.00 Exc VAT2-3 working daysPart No.9365A
Side Lamps
-
Butler Side Light suitable for Case International - Models With Round Fenders.
Supplied With Bulb.£15.00 Inc VAT £12.50 Exc VATIn stockPart No.5029
Beacons
-
Beacon Bracket suitable for Case International - Supplied with weather rubber cap for when beacon not in place.
Anodised plating for weather resistance.
Pin Height: 100mm.
Fixing Slots: 11mm x 22mm,
Fixing Slots Centre to Centre: 55mm.
£11.99 Inc VAT £9.99 Exc VAT2-3 working daysPart No.8451 -
Beacon Bracket suitable for Case International - Supplied with weather rubber cap for when beacon not in place.
Anodised plating for weather resistance.
Pin Height: 100mm.
Fixing Slots: 11mm x 22mm,
Fixing Slots Centre to Centre: 80mm.
£9.35 Inc VAT £7.79 Exc VAT2-3 working daysPart No.8452 -
Beacon Bracket suitable for Case International - Supplied with weather rubber cap for when beacon not in place.
Anodised plating for weather resistance.
Pin Height: 95mm.
Fixing Hole : 8mm
Fixing Holes Centre to Centre: 38mm.£9.35 Inc VAT £7.79 Exc VATIn stockPart No.8450 -
Rotating Warning Beacon suitable for Case International - For Negative Earth Tractors
Fixed Pin Fitting.
Pin Fitting : 24mm.
Overall Height: 60mm.
Diameter: 125mm.
12V H1 Halogen Bulb.12V / 55W , 24V / 70W.
Impact Resistant Lens.
CE Approved.
Replacement Bulb - Agriline Ref: 9368<... Show More£25.98 Inc VAT £21.65 Exc VAT2-3 working daysPart No.54028
Rotating Warning Beacon suitable for Case International - Flexible Stem.
Pin Fitting : 24mm.
Overall Height: 315mm.
Diameter: 127mm.
12V H1 Halogen Bulb.
Impact Resistant Lens.
Operating Temperature -30° to 50°.
E Approved.
Replacement Bulb - Agriline Ref: 9368Currently unavailablePart No.A-186
